SBE II owners...

[Drundel]

Do me a favor and look down your barrel for the choke fit. Is there a noticeable gap where the choke meets the barrel? Then run an object down the barrel (like a pen with a square end) and tell me if you can feel a pretty good "bump." To me it feels like the choke is a bit short and doesn't seat all the way.

Thx

[Camo]

Please tell me it isn't so!......I'll check tonight and let you know.

[benddg]

This is why I replied to a couple other of your post about the diameter of the barrel end of the chokes.

[benddg]

I think the SBE II

[benddg]

Can't edit post on this forum . I think SBE II and Xtrema chokes are the same. SRM says they are. May not get the same patterns because of bore, but they will interchange.

[Drundel]

Originally posted by Camo:
Please tell me it isn't so!......I'll check tonight and let you know.

Any update?

I measured mine, the length of the tube and where the bottom of the recess and they were the same length, so the choke fits right, not sure why there is a bump.

[Drundel]

Originally posted by benddg:
Can't edit post on this forum . I think SBE II and Xtrema chokes are the same. SRM says they are. May not get the same patterns because of bore, but they will interchange.

Yep, I'd had a few people tell me that, different bore dia. but same thread pattern.

[MASTERBLASTR]

if you put a benelli crio tube (.721") in a beretta optima plus (.733") the lead column will hit the choke exerting maximum pressure in the threads of the choke.

believe me I miked mine with professional intruments and measurements are correct.

dont even try a full choke crio system in a beretta it would be equal to card shooting chokes.

Joe