I just fininshed installing my Carrier Comp 7 rnd. mag tube,

[Tackelbarry]

follower, and spring and the fit and finish is GREAT! I followed the instructions, which are very detailed, and the install went smoothly. As warned, Benelli did apply an ample amount of the thread locker at the factory. Following the instructions, I used a heat gun and an infrared thermometer to complete the install. My thermometer read 313 degrees when I attempted to unscrew the original tube and it took little to moderate pressure. I had to actually apply a little more pressure to unscrew the tube as it was beginning to cool. I used the hard nylon brush to easily remove the rest of the thread locker and then screwed the new Carrier Comp titanium 7 rnd. tube in to place. I also used a small drop of the blue lock-tite during installation. I am very happy with the product and plan to buy another for my L.E. model 11721 when it arrives.

Sincerely,

Scott Jens
Check Six Training LLC
www.chksixtraining.com
C.H.P.D. (ret.)

[saym14]

congrats. like you said its not hard to do and Carrier comp makes an excellent product. cant wait to get thier bolt handle