R1 scope rail issue

[satcor]

Just got my R1 Comfortech and the scope rail that came with the rifle has mounting holes that do not match the ones on the rifle. Anyone had this problem?

[tucker301]

No.
It sounds like the dealer may have given you the wrong rail.
Go back to him.

[satcor]

Originally posted by tucker301:
No.
It sounds like the dealer may have given you the wrong rail.
Go back to him.

[satcor]

The box was sealed and the rail was inside the case. It looks like a factory miss..

[tucker301]

Any chance you could post a picture of the mismatch?
Either way, go back to the dealer and request that they correct the problem.

If they refer you to Benelli customer service, remind them that THEY are the dealer and as such, are obligated to the customer as much or more than the manufacturer.

It should be they who are on hold for 15-20 minutes, not you.
If they have a problem with that, they should complain to their Benelli rep. the next time they speak.

[tucker301]

One more thought, sactor.
The rail is labeled as to which end goes towards the front (muzzle) of the rifle.
Are you installing it with the arrow pointing towards the muzzle?

[satcor]

No matter how I try to install it I can't get more than one hole to line up, it has a total of 5 mounting holes.

[satcor]

I have a new rail on the way as we speak. They said it was very unusual, hope the barrel is not drilled wrong....

[tucker301]

If convenient, try a base for a Browning BAR.
3 out of 5 should line up.
If not, it is indeed drilled wrong.